1.开机前准备工作
(1)检查抽热风管铡刀是否打开。
(2)检查电源及电机电源，北面进球处是否有异物。
(3)将提升机，输送架位置是否摆放好。
2.开机顺序
(1)打开抽热风管铡刀后，打开1号或2号风机，直至有热风出来。
(2)打开烘干机电机，提升机电机。
(3)运转正常后将待烘干物品每次一袋倒入北面烘球入口处。
3.关机顺序
(1)检查烘干机内有无物料投出。
(2)先关闭1号或2号风机电源，在把抽热风管铡刀关闭。
(3)依次关闭烘干机电源及提升机电源。
4.注意事项
(1)开机烘球时，应先将烘干机运转一会，看是否有黄球出现。如有出现，应先用废球倒入烘球投料口，直至烘球出料口无黄色异物等出现，才能正常生产。
(2)如以上办法还不能解决，应叫机修工把烘干机出料口处盖子开打，然后进入烘干机内把机内黄球异物等清理出烘干机，清理干净后把出料口出盖子盖好，在运转试生产。
中译英：
1 Preparations before starting
(1) Check the pumping hot air pipe cutter is open.
(2) Check power and motor power, the goal is whether foreign bodies.
(3) Lift, transport rack positioned well.
2 Boot sequence
(1) Open pump air pipe cutter, opened in 1or 2, fan, until the hot air out.
(2) Open the drying machine, hoist motor.
(3) Normal operation will be dry goods every time a bag into the north entrance to bake the ball.
3 Shutdown sequence
(1) Check the drying machine has no material cast.
(2) The first closed in 1or 2, the power switch of the fan, the hot air pipe cutting off pump in.
(3) Turn off power and enhance machine drying machine.
4 Matters needing attention
(1) Boot drying ball, first drying machine running for a while, to see if there is a yellow ball. If have, should use the waste ball into a baking ball feeding mouth, to bake the ball outlet no yellow such as foreign bodies, the normal production can.
(2) If the above methods can not solve, should call the mechanic to dryer outlet lid open, then enters a drying machine to machine Neihuang ball foreign bodies such as clearing and drying machine, clean up after the outlet lid cover, in the operation of pilot production.
(图/文http://www.qitaibio.com/)
加入收藏
